1/6/2024 0 Comments Powered rails![]() Another advantage of the system is that the rover can pass gates and tunnels. It's a very complex system, but it enables a continuos operation of the robot 24h a day and 7 days a week. A microcontroller observes the charging procedure to avoid damage of the batteries during operation. If the connection to the metal stripes is reestablished, the robot is powered through the current rail system and the batteries get recharged. Whenever the connection to the external power supply is interrupted, the robot is fed with electricity through the batteries, discharging these buffers. Large capacitors or batteries can be used to buffer electric energy. A computer attached to this system will crash. In practice there is no steady contact, because the surfaces of the metal stripes and the sliding contacts are not ideally plain and clean. A fixed voltage regulator is needed to power the computer correctly. That makes the arrangement work properly even with a poorer engineering tolerance of the base plate.Īccross the diodes and metal stripes there is a noticeable voltage drop of 1.83V, thus the voltage applied to the rails at base plate must be higher than the input voltage needed at the rover electronics. When using more than 5 sliding contacts, the gap between the metal stripes at the base plate can be enlarged. Less visible, but more complex to manufacture are multiple contact points that are joined at the reverse side of the base plate. Instead of massive metal stripes, you can also use two thin cables with a distance equal to the width of the metal stripes. The outer diameter of the circle, the sliding contacts are arranged on, must be large enough so that three metal stripes can be touched at once. The width of the metal stripes must be larger than the gap between two sliding contacts. The gap between the metal stripes must be slightly larger than the diameter of the sliding contacts or else they will shorten two stripes! At the drawing, the positive terminal is always located to the left and the negative terminal to the right of the load. With the diodes, the polarity at the input terminals of the electronic board doesn't change during movement. If that arrangement is pulled over the base plate, at least two sliding contacts are connected to two different metal stripes at any time. Rails with ground potential alternate with +8.5V rails.Īt least 5 round sliding contacts arranged on a circle and 10 diodes are needed to power the robot. Continued abuse of our services will cause your IP address to be blocked indefinitely.The power supply system shown here is made of a wooden base plate with metal stripes and sliding contacts. Please fill out the CAPTCHA below and then click the button to indicate that you agree to these terms. ![]() If you wish to be unblocked, you must agree that you will take immediate steps to rectify this issue. If you do not understand what is causing this behavior, please contact us here. If you promise to stop (by clicking the Agree button below), we'll unblock your connection for now, but we will immediately re-block it if we detect additional bad behavior.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |